Devices and sensors

SDIG2-OW-48-80 Discrete inputs module, 48 ports, 0-80V signal

General availability


Загрузка изображения

Discrete inputs module for 48 ports with the input signal level ranging from 0 to 80 Volts. The logic chain is electrically unbound from the measurement input ports. The board has lightning protection circuitry for the porReconts, requires grounding. The levels of logic "0" and "1" are configurable on each port.


Discrete inputs module for 48 ports with the input signal level ranging from 0 to 80 Volts. The logic chain is electrically unbound from the measurement input ports. The board has lightning protection circuitry for the ports, requires grounding. The levels of logic "0" and "1" are configurable on each port.

Recognised by the controller as a single device with 48 sub-ports and so requires a renewal of firmware for older controllers. This change allows to receive state information for all the 48 ports in a single response.

Separate ports of the device can operate in the "dry contact" mode, which requires a jumper switch for the corresponding port.

There is a LED indication board that can optionally be connected to this device, with 48 LEDs - one per each port. In case a port is switched off in software, no measurement is performed for the port and so the corresponding optional LED will be constantly off. The controller will also be getting a logic "0" for such a port.

Checking for data integrity is performed with CRC16 (cycling redundancy check, 16 bits).

Data protocol - 1-Wire working at 12 Volts. The board is powered with 12V.

This device is produced on order.

CONTACTS

  • Our Address: Ukraine, Kyiv 02660
    str. Chervonotkatska 94
  • Email: office@xcs.com.ua
  • Web-site: impulse112.com
    xcs.com.ua
  • Phone number: +38 044 451 87 42