Devices and sensors

SDOG2-OW-8R Control module with relay outputs, 8 control ports

General availability


Загрузка изображения

SDOG2-OW-8R - this is a module of 8 relay outputs. It connects to the controller Impulse 112 and allows you to execute control (enable or disable) over equipment. Each port of the module is " seen" to the controller as a separate unit with its own control registers.


SDOG2-OW-8R is a module with 8 relay outputs. It connects to the controller Impulse 112 and allows you to execute control (enable or disable) over equipment. Each port of the module is " seen" to the controller as a separate unit with its own control registers.

A change of the port status from enabled to disabled and vice versa generates an event in the controller, so when this module is used in fully automatic scenarios with the Impulse 112 controller, these events can also be used in the control logic.

Модуль предоставляет возможность как индивидуального включения/выключения каждого реле, так и одномоментное включение/выключения указанного количества реле, в том числе и поочередное выключение через заданный промежуток времени. Имеет функцию запоминания последнего состояния реле до пропадания питания с восстановлением состояния реле, которое было до пропадания питания. Данная функция включается/выключается для каждого реле индивидуально.

The module has the capability to switch on/off each relay individually, to switch on/off a number of relays at one command, to switch on/off at one command sequentially with a specified delay between each. Has the function of storing the last state before the power failure with the restoration of the state of the relays right after the power supply is restored. This feature can be enabled / disabled for each relay individually.

The maximum current at the voltage of 220 V - 0.7 A, at 24 V - 2 A.

This sensor to communicate with the controller uses the digital protocol 1-Wire with the potential of 12 V. The data sent to the controller is checked using the CRC (cyclic redundancy check) algorithm. The processing unit is electrially untied from both the control plane towards relay outputs and the digital bus to the controller.

The ports of thesensor are automatically recognized by the controller and can be easily configured.

The first port of the module exhibits special registers that allow simultaneous switching to the on or off positions on all 8 relay ports.

CONTACTS

  • Our Address: Ukraine, Kyiv 02660
    str. Chervonotkatska 94
  • Email: office@xcs.com.ua
  • Web-site: impulse112.com
    xcs.com.ua
  • Phone number: +38 044 451 87 42